Desk Control 520 Reset

How to hard reset the programmable control continued press and hold buttons 1 2 and the up arrow at the same time until the display reads s 5.

Desk control 520 reset. This initialisation procedure refers to all linak desk panels including. Control panel with memory function and led. The display will now read e61. Resetting your uplift desk is quick and simple.

Unplug the desk for 20 seconds. Logicdata cannot accept responsibility for incorrect operation or use of the products other than for the intended purpose. Here are the steps you ll need to reset your height adjustable desk. 4 3 9 reset control unit to factory settings.

Use the control to decide if the actuator or lifting column should initiate movement. The desk height will be displayed when the desk stops. Learn how to initialise your height adjustable office desk equipped with a linak motor system. Then you are good to go.

Plug it back in. Press the down buttons until the desk beeps one more time or 20 seconds pass. If the table is not responding when you press an arrow key or a memory key it may need to be reset. After assembly after disconnection from the power supply or after any impact on the table top.

Defective drive contact customer service reset the desk may need to be reprogrammed reset after any of the following. 29 4 3 10 cascading. Press the up and down buttons until the desk lowers all the way and beeps or 20 seconds pass. Is applied when the electric height adjustable desk moves down.

To drive the desk to a preset position hold your fi nger on the stored number button. The display will show go1 go2 or go3 while the desk is driving to the memory position. Errors and omissions excepted. A linak control is the unit you use to control the movements of a linak actuator system.

For more information on our uplift desks or to purchase an uplift desk visit. Wait a full 20 seconds. Control unit for an electric height adjustable desk compact for firmware version 1 7 6 or higher rev 3 subject to change without notice. To the control unit and the drives.

For linak actuator systems there is a variety of control types for various applications. Compacteco control units may only be used for the intended purpose i e. Operating instruction motor drive pxd compact to control and drive hydraulic lifting systems made by ergoswiss ag it is essential to read this operating instruction thoroughly before commissioning the system. Without a mechanical brake cut out sensitivity may be reduced.